Set Up Speakers - Denon AVR-3311CI Owner's Manual

ENGLISH
Connect
5.1-channel + 2.1-channel connection
If front speakers for 2-channel playback are connected to the SURR. BACK/AMP ASSIGN terminals, both
speakers for multichannel playback and for 2-channel playback can be used, by switching.
In this case, set "Set up "Amp Assign"" (vpage 53) to "2CH".
FL FL
SW
C
SL
• For switching multichannel playback and 2-channel playback, see "Selecting a listening mode (Surround
mode)" (vpage 45).
• If "2ch Direct/Stereo" – "Setting" (vpage 83) is set to "Custom", settings for 2-channel playback
speakers can be made.
52
Multi channel playback
(Surround mode)
Switching
FR FR
2-channel playback
(Direct/Stereo mode)
SR
For speaker impedance and speaker cable connections, see page 4.

Set up speakers

Here we describe how to set up speakers other than 5.1-channel speakers.
For the method of setting up 5.1-channel speakers, see "Simple version", "Set up speakers
(Audyssey ® Auto Setup)" (vpage 6).
First install and connect the speakers to this unit.
Before Auto Setup measurement, the settings shown below can be made.
• Changing the amplifier assignment (Amp Assign)
The signal output from the SURR.BACK/AMP ASSIGN speaker terminal of this unit can be switched to
match your speaker environment (vpage 53 "Set up "Amp Assign"").
• Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and
measuring time can be reduced (vpage 53 "Set up "Channel Select"").
1
Set up the
remote control unit
n Set up the zone mode
ZONE SELECT
Press to switch the
zone mode to "MAIN".
The "MAIN" indicator lights.
Press ZONE SELECT
n Set up the operation mode
Press AMP to set the remote control
unit to amplifier operation mode.
Press AMP
around items indicate the settings.
2
Connect the setup microphone.
When the setup microphone is
connected, the following screen is
displayed.
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ XT
STEP1 Preparation [1/6]
Connect the speakers
and place them accord-
ing to the recommenda-
tions in the manual.
Set the following
items if necessary.
Amp Assign
Channel Select
Auto Setup Start
ENTER Enter RETURN Cancel
Start Auto Setup