Denon AVR-1612 Manual page 29

STEP 2 (Continued)
Detect & Measure (Main)
NOTE
If "Caution" is displayed:
Go to "Error messages" (vpage 16),
check any related items, and perform the
necessary procedures.
If the problem is resolved, return and restart
"Audyssey ® Auto Setup".
When performing Audyssey ® Auto Setup over
again
ui ENTER
Press to select "Retry", and then press
When measuring has stopped
RETURN B
q Press , to the "Cancel Auto Setup?" prompt is
displayed.
o
ENTER
w Press to select "Yes", then press
Setting up the speakers again
Repeat the operation from step 4 of STEP 1 Preparation
STEP 3
Measure (2nd – 6th)
• In STEP 3, you will perform measurements at multiple positions (two
to six positions) other than the main listening position.
• Just one position can be measured but measuring multiple positions
increases the accuracy of the correction of acoustic distortion within
the listening area.
10
Move the setup microphone to
position 2, use
"Measure", and then press
ENTER .
The measurement of the second
. position starts. Measurements can be
made in up to six positions.
Measure (2nd)
Please place the
.
microphone at ear
height at 2nd
listening position.
Measure
.
Next
If you want to omit measurements from the next position onward,
select "Next Calculate".
STEP4 Calculate
(Go to
11
Repeat step 10, measuring positions 3 to 6.
When measurement of position 6 is completed, a
"Measurements finished." message is displayed.
Measure (Finish)
Measurements finished.
Retry
Next
ui to select
Audyssey Auto Setup MultEQ
Calculate
[ENTER] Enter [RETURN] Cancel
)
Audyssey Auto Setup MultEQ
Calculate
[ENTER] Enter [RETURN] Cancel
14
Set up speakers (Audyssey ® Auto Setup)
STEP 4
Calculate
12
On the screen, use ui
STEP 3
ENTER
Calculate", and then press
Measuring results are analyzed, and the frequency response of
each speaker in the listening room is determined.
Audyssey Auto Setup
Calculate
Now calculating
Please wait
0%
• Analysis takes several minutes to complete. The time required for
this analysis depends on the number of speakers connected.
The more connected speakers there are, the longer it takes to
perform analysis.
to select "Next →
.
MultEQ
vSee overleaf