Denon AVR-1612 Manual page 30

STEP 5
Check
13
Use ui to select the item you
want to check, and then press
ENTER .
Audyssey Auto Setup
Check
Check processing resuit.
To proceed, press
"Next".
Sp.Config. Check
Distance Check
Ch.Level Check
Crossover Check
Next Store
[ENTER] Enter [RETURN]
• Subwoofers may measure a greater reported distance than
the actual distance due to added electrical delay common in
subwoofers.
RETURN B
• If you want to check another item, press
14
ui
Use to select "Next → Store" and then press
ENTER
.
NOTE
• If the result differs from the actual connection status, or if "Caution!"
is displayed, see "Error messages" (vpage
Audyssey ® Auto Setup again.
• If you change speaker positions or orientation, perform Audyssey ®
Auto Setup again to find the optimal equalizer settings.
STEP 6
Store
15
Select "Store" and then press
Save the measurement results.
Store
Press "Store" to
store calculation
result.
MultEQ
Store
Cancel
Store
Now storing
Please wait...
.
0%
• Saving the results requires about 10 seconds.
• If the measuring results are not to be saved, press
16). Then carry out A message "Cancel Auto Setup?" will be displayed. Press o then
select "Yes". All the measured Audyssey ® Auto Setup data will
be erased.
• During saving of measurements results, "Now storing
wait..." is displayed. When saving is completed, "Storing complete.
Auto Setup is now finished." is displayed.
NOTE
During saving of measurement results, be sure not to turn off the
power.
ENTER
.
Audyssey Auto Setup MultEQ
[ENTER] Enter [RETURN] Cancel
Audyssey Auto Setup MultEQ
RETURN B
.
Please
15
Set up speakers (Audyssey ® Auto Setup)
Finish
16
Unplug the setup microphone from the unit's SETUP
MIC jack.
17
Set Audyssey Dynamic Volume ® .
Audyssey Auto Setup
Finish
Storing complete.
Auto Setup is now finished.
Please unplug microphone.
Turn on Dynamic Volume?
Yes
No
[ENTER] Exit
• This feature adjusts the output volume to the optimal level while
constantly monitoring the level of the audio input to the unit.
Optimal volume control is performed automatically without any
loss in the dynamism and clarity of the sound when, for example,
the volume suddenly increases for commercials shown during
television programs.
n When turning Dynamic Volume ® on
ENTER
• Use u to select "Yes", and then press
The unit automatically enters "Evening" mode.
n When turning Dynamic Volume ® off
ENTER
• Use i to select "No", and then press
NOTE
After performing Audyssey ® Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey ® Auto Setup again.
MultEQ
.
.