2 ] Downloading - Denso BHT-7000 User Manual

[ 2 ] Downloading

If you download a file having the same name as one already used in the user area of
the target memory in the BHT, the newly downloaded file replaces the old one.
DOWNLOAD
1:FILE
2:HT<-->HT COPY
NOTE Preparation for Copying between the BHTs
Before downloading to the BHT from another BHT, make the following prepa-
ration:
• At each BHT, set the interface port. The default is an optical interface
(Optical).
Interface setting procedure: Starting on the SYSTEM MENU, select "4:SET
SYSTEM," "5:COMMUNICATION," and "3:COM PORT." On the SET COM
DEFAULT PORT screen, select the optical interface (Optical) or direct-con-
nect interface (Connector) of "2:SYSTEM MODE."
• When using the direct-connect interface, pull out the connector cover on
each BHT to expose the direct-connect interface port. Connect the BHTs via
those ports with the direct-connect interface cable (having 3-pole mini stereo
plugs). For the details about the cable, refer to Chapter 3, Section 3.1.
• On the uploading BHT, run System Mode and select "3:UPLOAD" and "3:HT<-
->HT COPY."
* For BHT-7000s having a 26-key pad, use F5 , F6 , F7 and F8 keys instead of
, and keys, respectively
Chapter 2. Getting Started the BHT-7000 and System Mode
Selecting "2: DOWNLOAD" on the SYSTEM MENU
calls up the screen shown at left.
1 FILE
2 HT<-->HT COPY : Downloads all of the files,
Select a desired item by using the numerical keys
or * keys, and the selected item be-
* and
comes highlighted. Then press the ENT key.
To return to the SYSTEM MENU, press the C key.
39
: Downloads a user program
file or data file to the user
area of the BHT.
system parameters, and cal-
endar clock data stored in
the connected BHT.
This function enables copy-
ing between the BHTs.
For the preparation to be
made preceding the start of
this function, refer to NOTE
below.
, ,