Specify The Ip Addresses That The Cradle Assigns - NETGEAR AirCard Smart Cradle DC112A User Manual

Your changes are saved.
If you changed the LAN IP address of the cradle, you are disconnected when this change
takes effect.
9. To reconnect, close your browser, relaunch it, and log in to the cradle.

Specify the IP Addresses That the Cradle Assigns

By default, the cradle acts as a Dynamic Host Configuration Protocol (DHCP) server. The
cradle assigns IP, DNS server, and default gateway addresses to all computers connected to
the LAN. The assigned default gateway address is the LAN address of the cradle.
These addresses must be part of the same IP address subnet as the cradle's LAN IP
address. Using the default addressing scheme, define a range between 192.168.100.2 and
192.168.100.254, although you can save part of the range for devices with fixed addresses.

To specify the pool of IP addresses that the cradle assigns:
1. Launch a web browser from a computer or wireless device that is connected to the
Smart Cradle.
2. In the address field of the browser, enter http://netgear.cradle or http://192.168.100.1.
A login prompt displays.
3. Enter the cradle user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
The BASIC Home screen displays.
4. Select ADVANCED > Setup > LAN Setup.
5. Make sure that the Use Router as DHCP Server check box is selected.
AirCard Smart Cradle
Network Settings
76