Set Up An Ipv6 Pass Through Internet Connection - NETGEAR AirCard Smart Cradle DC112A User Manual

The screen adjusts:
The cradle automatically detects the information in the Router's IPv6 Address on LAN
field. This field shows the IPv6 address that is acquired for the cradle's LAN interface.
The number after the slash (/) is the length of the prefix, which is also indicated by the
underline (_) under the IPv6 address. If no address is acquired, the field displays Not
Available.
6. Select an IP Address Assignment radio button:
• Auto. Your cradle uses any remote relay gateway that is available on the Internet.
This is the default setting.
• Static IP Address. Enter the static IPv4 address of the remote relay gateway. Your
IPv6 ISP usually provides this address.
7. Select an IP Address Assignment radio button:
• Use DHCP Server. This method passes more information to LAN devices but some
IPv6 systems might not support the DHCv6 client function.
• Auto Config. This is the default setting.
This setting specifies how the cradle assigns IPv6 addresses to the devices on your
home network (the LAN).
8. (Optional) Select the Use This Interface ID check box and specify the interface ID to be
used for the IPv6 address of the cradle's LAN interface.
If you do not specify an ID here, the cradle generates one automatically from its MAC
address.
9. Click the Apply button.
Your settings are saved.

Set Up an IPv6 Pass Through Internet Connection

In pass-through mode, the cradle works as a Layer 2 Ethernet switch with two ports (LAN and
WAN Ethernet ports) for IPv6 packets. The cradle does not process any IPv6 header
packets.
AirCard Smart Cradle
Internet Setup
33