Replacing Engine Oil Filter - CanyCom CM 230 Operator's Manual

Replacing Engine Oil Filter

Mating surface "B"
Sealing
surface "A"
5314M-0709-010-E
Maintenance
1. Drain the engine oil.
2. Remove the oil filter cartridge, using an oil filter
3. Clean the mating surface "B" for mounting the
Filter cartrige
4. Apply a film of new oil to the sealing surface
5. Tighten the new filter cartridge manually, until
6. Add the specified engine oil. (See Page 47.)
7. After starting the engine, check that the oil
-51-
wrench.
filter cartridge to the engine.
"A" of the filter cartridge before mounting it.
the sealing surface "A" touches the mating
surface "B", then further tighten the cartridge
by a 3/4 turn with the oil filter wrench.
does not leak from the mounting part of the
filter cartridge.
7