CanyCom CM 230 Operator's Manual page 46

6
Rotary height adjusting switch
5314M-0602-030-E
Accelerator lever
5314M-0603-010-E
Speed change lever
L
N
5317M-0604-050-E
Operation
H L
H
4. If necessary, change the blade height by
adjusting the rotary height adjusting switch.
5. Shift the accelerator lever to "HIGH" and
increase the rotation speed of the engine.
6. Shift the auxiliary speed change lever to
"LOW", and start the cutting work at low
running speed. (Adjust the running speed
according to work conditions.)
7. When the working load is heavy (due to cutting
a large amount of material), reduce running
speed or raise cutting height and cut two
times.
NOTE
* When first using machine after purchasing,
use on level area and slowly perform cutting
work in straight, slightly overlapping lines.
-40-