Maintenance And Storage - CanyCom CM 230 Operator's Manual

2

Maintenance and Storage

1. Before maintaining or storing the machine, disconnect the running and cutting systems
from their driving units, apply the parking brake, and pull the ignition plug cord out. Before
storing the machine, adjust, clean, and repair the movable parts.
2. Remove remaining grass and foreign matter from the cutter blades and under carriage to
prevent fires.
3. Cool the engine completely and do not place any flammable material near the machine.
4. Park the machine on level ground. Any person not trained to handle the machine should
not maintain the machine.
5. Use jacks if necessary to raise machine.
6. Carefully relieve pressure from the pressurized parts.
7. Always remove the battery cords and ignition plug cords before repairing any part.
Remove the minus side first, and then the plus side. Install the plus side first, and then
the minus side.
8. Check the cutting blades with caution by covering the blades with proper material or
wearing protective gloves. When replacing the cutting blade, do not straighten or weld it.
9. Keep hands and feet off the moving parts. Do not make adjustments when the engine is
operating.
10. Charge the battery in a well ventilated area without sparks or flammable material nearby.
Pull the charger power plug out before connecting or disconnecting the charger to or from
the battery. Wear protective clothing and use insulated tools.
11. Keep all parts in clean, dry storage and ensure that they are correctly installed. Replace
all deteriorated labels with new ones.
Safety Rules
-4-