Picture Off-Centering; Selection Of Presentation Mode - Koden MDC-1840BB Operation Manual

MDC-1840BB/1841BB/1860BB/1810BB/1820BB Series
Operation Manual
(5) Move 1st VRM to touch the right front of the second target. The distance between
the two targets will be shown on the bottom right center of the screen.
1st EBL
1st VRM
Target 1
Figure 5.3 Measuring the distance between two points

5.5.12 Picture off-centering

The radar picture can be offset to any position within 2/3 of the screen radius. Use the
following procedure.
(1) Move the cross cursor to a desired point to be offset.
(2) Press the OFF CENTER key. The entire radar picture will be moved to the
specified point.
(3) A further press of the key will reset the picture to the center position.

5.5.13 Selection of presentation mode

The following four kinds of presentation modes are available.
(1) Head Up, Relative Motion
(2) North Up, Relative Motion (Note: Bearing information must be provided)
(3) Course Up, Relative Motion (Note: Bearing information must be provided)
(4) True Motion (Note: The bearing and speed information must be provided)
To select the presentation mode, press the MODE key. Every press of the key will
change the presentation mode in the above sequence.
0093142122-10
Target 2
Target 2
1st EBL
1st VRM
Target 1
EBL REL
o
20.0
Chapter 5
Basic Operation
The cursor position
data is shown here
CURSOR REL
110.0
2.000 NM
VRM
3.00
NM
5-13
o