Log Pulse (Log Pulse Rate); Gyro (Gyro Gear Ratio); Serial Input Format; Serial Transmit (Serial Output Interval) - Koden MDC-1840BB Operation Manual

MDC-1840BB/1841BB/1860BB/1810BB/1820BB Series
Using The Menu
Table 6.3 The relation of the sentences and available device names
Sentence Talker identifier available
VHW VD
VM
VW
VBW VD
VDR VD
VTG GP
VD

6.4.1.5 LOG PULSE (Log Pulse Rate)

This menu is used to set up the incoming log pulse ratio, which is fed to the Gyro
Interface unit, type KSA-08A built into the processor unit.
The following pulse ratios can be selected: 100, 200, 400 and 500 pulses/nm.
Indication
LOG PULSE

6.4.1.6 GYRO (Gyro Gear Ratio)

This menu is used to set up the gyro gear ratio used, which is fed to the Gyro Interface
unit, type KSA-08A. The following pulse ratios can be selected: 36X, 90X, 180X and
360X.
Indication
GYRO

6.4.1.7 Serial Input Format

This menu is used to select the type of incoming serial signal sent from external
equipment for each data input connector from DATA1 to DATA3. The following signal
formats can be selected:
SERIAL

6.4.1.8 SERIAL TRANSMIT (Serial Output Interval)

This menu is used to select the interval of transmission of outgoing signals.
Indication
SERIAL TRANSMIT
93142122-07
On-screen display
DO LOG/WT-Speed
LOG
LOG
DO LOG/BT-Speed
DO LOG
GP
DO LOG
Meaning
Log pulse count for 1 NM
Meaning
Gear Ratio for Gyro repeater
IEC61162-1, NMEA-0183,NMEA-0182,KODEN-717
Meaning
Serial Output Interval
Chapter 6
Operation Manual
Device name
Doppler LOG
Speed LOG, magnetic
Speed LOG, mechanical
Doppler LOG
Doppler LOG
GPS receiver
Doppler LOG
Selection
100, 200, 400, 500
Selection
36, 90, 180, 360
Selection
0.1 to 9.9 SEC
6-17