Systemsetup; Range Disp (Range Scale Display); Buzzer; Language - Koden MDC-1840BB Operation Manual

Chapter 6 MDC-1840BB/1841BB/1860BB/1810BB/1820BB Series
Using The Menu
6.4.2 SYSTEM SETUP
This menu is used to select various functional parameters, which are specific to
respective users and their operating conventions.
NOTE:
This menu is protected from ordinary operations. To use this function, turn off the
radar se first. Press and hold the MODE key and turn the equipment on. When the standby
condition is established, turn the radar on to enter the following menu functions.

6.4.2.1 RANGE DISP (Range Scale Display)

This function is used to select the range scale notation system; decimal or fraction.
Example: DECIMAL: 0.125, 0.25...
Indication
RANGE DISP

6.4.2.2 BUZZER

This function is used to turn on or off the electronic buzzer.
Indication
BUZZER
NOTE:
To momentary silence the audio alarm, press the AUDIO OFF key.

6.4.2.3 LANGUAGE

This function is used to change the Indication Language.
Indication
LANGUAGE

6.4.2.4 DELAY (Transmission Timing Adjustment)

This function is used to adjust the transmission delay time in order to coincide the
radar transmission timing with the start of the radar sweep. In practice, the Figure 4.7
in Chapter 4 illustrates the result of the setting, whether it is properly adjusted or not.
To effectively perform this setting, find an appropriate object that is straight across
from your radar.
Indication
DELAY
Carry out the following procedure to set up the proper transmission delay time.
(1) Highlight DELAY and press the ENT key to set up the selection ready status.
(2) Press the Joystick up or the down until a straight picture is shown on the screen.
(3) Press the ENT key to exit.
6-18
FRACTION: 1/8, 1/4....
Meaning
Range Display Mode
Meaning
Alarm Buzzer
Meaning
Indication Language
Meaning
Radar Echo Timing
Operation Manual
Selection
DECIMAL, FRACTION
Selection
OFF, ON
Selection
ENG, JPN
Selection
0 to 99
93142122-07