System Setting Modes; Normal; Cross; Master-Slave - Koden MDC-1840BB Operation Manual

Chapter 6 MDC-1840BB/1841BB/1860BB/1810BB/1820BB Series
Using The Menu

6.9.2 System Setting Modes

6.9.2.1 NORMAL

This is the mode to use two radars as independent radars. The CONT1 controls the
SCAN1 in the system diagram shown above, and the CONT2 controls the SCAN2
independently. Two radars will operate as independent two radars without any effects
each other.

6.9.2.2 CROSS

This is the mode with exchanging two scanner units, and operating two independent
radars. The CONT1 controls the SCAN2 in the system diagram shown above, and the
CONT2 controls the SCAN1 independently. Two radars will operate as scanner
exchanged independent two radars without any effects each other.

6.9.2.3 MASTER-SLAVE

On this mode, one radar system operates normally and another display unit operates
as a monitor.
6.9.2.3-1. CONT1: MASTER(Radar), CONT2: SLAVE(Monitor)
The CONT1 controls the SCAN1 in the system diagram. The radar with CONT1 and
SCAN1 will operate a independent radar system. The CONT2 will receive and indicate
the radar image with SCAN1 radar signals. But the CONT2 could control nothing of
the SCAN1. The SCAN2 is idling on this mode.
The range scale can be changed at the CONT2 freely but without SCAN1 controls
such as transmit pulse width, repetition, receiver band width. When indicate the short
range radar image at the CONT2 with long pulse transmitting on the SCAN1, there
may be a strange radar image on the screen. But this is not a problem of the system.
On the contrary, short pulse on the SCAN1, long range on the CONT2, there may be
a strange radar image on the screen. of CONT2 but this is not a problem also. Please
use the display ranges at the CONT2 within indicating normal radar image.
You can use functions without scanner control freely such as EBL, VRM, Gain, STC
control on the CONT2.
6.9.2.3-2. CONT1: SLAVE(Monitor), CONT2: MASTER(Radar)
The CONT2 controls the SCAN2 in the system diagram. The radar with CONT2 and
SCAN2 will operate a independent radar system. The CONT1 will receive and indicate
the radar image with SCAN2 radar signals. The other functions and cautions are the
same.
The SCAN1 is idling on this mode.
6-38
Operation Manual
93142122-07