MDC-1840BB/1841BB/1860BB/1810BB/1820BB Series
Using The Menu
Indication
PLOT CONTR
Changes the brilliance of plotting symbols and ID number used for the EPA and ATA
functions.
Indication
DATA CONTR
Changes the brilliance of texts and graphics outside the PPI screen.
6.3.1.2 Navigation Position Alignment
This function is used to move a user defined Navigation Line(s) or map to a desired
position on the screen. To do so, perform the following procedure.
(1) Set the NAV ALIGN MODE to MANUAL in the DISP/NAV menu. Highlight the
prompt NAV ALIGN d-LAT or d-LON.
(2) Press the ENT key to set the NAV ALIGN.
(3) Press the Joystick up or down to set the align value and press the ENT key.
Indication
NAV ALIGN d-LAT
d-LON
6.3.1.3 RADAR SENSITIVITY (Selecting Auto/Man Receiver Functions)
Indication
AUTO SELECT
NOTE:
The AUTO function provides automated Gain, STC and FTC functions without the
need of operator's control, giving an optimized radar picture while it is activated.
The AUTO 1 is suited for coastal navigation. In this mode the picture is optimized for
short and mid ranges with reduced noise and weather clutters.
The AUTO 2 is used for open sea navigation. In this mode the sea and weather
clutters are effectively reduced while the long-range performance is maintained.
The HARBOR mode is used for the navigation in a confined area such as a harbor,
inland waterway, canal, etc. where hard and tall objects give strong radar reflections
causing the picture to be saturated. Using this mode the Gain, STC and FTC are
effectively introduced to minimize such strong echoes while the picture definition is
maintained.
93142122-07
Meaning
Plot Contrast
Meaning
Data Contrast
Meaning
Manual Navigation Alignment
Meaning
Auto Function Select
Operation Manual
Selection
0 to 99
Selection
0 to 99
Selection
-1.000 to 1.000
-1.000 to 1.000
Selection
AUTO1, AUTO2, HARBOR
Chapter 6
6-11