Control Panel Brilliance; Displaying The Navigational Data - Koden MDC-1840BB Operation Manual

Chapter 5
Basic Operation
Bearing of Guard Zone
The Guard Zone width
The Guard Zone
depth
VRM for setting the
Guard Zone range
Figure 5.4 The outline of the Guard Zone Alarm

5.5.15 Control panel brilliance

The control panel illumination is set by default. To change the brilliance, use either the
following procedure.
(1) Keep pressing the PANEL key to change the panel illumination in 10 cyclic steps,
starting from OFF, increasing, decreasing and finally to OFF again.

5.5.16 Displaying the navigational data

Navigational data such as own ship's position, waypoint position and the distance and
bearing to a waypoint can be shown on the screen. Press the DATA DISP key to
display this data on the screen.
NOTE:
1. A navigator unit must be connected to the display unit.
2. The serial data format must be selected. Refer to Para 6.3 "SYSTEM: I/O SETUP
MENU" for detail.
Each press of the DATA DISP key changes the contents of the navigation display in
the following sequence.
5-16
MDC-1840BB/1841BB/1860BB/1810BB/1820BB Series
Guard Zone
>BRG
WIDTH 000.0
>RNG
DEPTH 0.100NM
EBL for setting the Guard
Zone bearing
Operation Manual
ALARM
o
000.0
o
0.500NM
0093142122-10