Hour Meter; Maintenance Menu; Antenna - Koden MDC-1840BB Operation Manual

MDC-1840BB/1841BB/1860BB/1810BB/1820BB Series
Using The Menu
(6) To perform the ATA test function, use the SYSTEM/BITE/ATA TEST menu.

6.4.3.3 Hour Meter

The following maintenance test items will be shown:
Items shown
TOTAL HOUR
TX HOUR

6.5 MAINTENANCE MENU

This menu is protected from ordinary operation. To activate this function, press and
hold the Mode Key and turn the unit on.

6.5.1 ANTENNA

The following maintenance test items will be shown:
Items shown
TUNE LEV.
TUNE VOL.
250V(HT)
MAG. CUR.
P.M. RX
P.M. TX
TYPE
MODE
250V(HT)
40V
NOTE: ID number varies according to the transmission power level as follows:
7: 6 kW, 0: 12 kW, 5: 25 kW
6.5.2 OPTION
Indication
ALARM
TM SYNC
HL BLINK
H SYNC
I.S. HDG
93142122-07
Meaning
Operation Hours Indicator
Transmit Hours Indicator
Meaning
Tuning Level Indicator
Tuning Voltage Level Monitor
250V monitor
Magnetron Current Monitor
Performance Monitor Receiver Level
Performance Monitor Transmitter Level
Antenna Type
Scanner Unit ID2
250V monitor
40V monitor
Meaning
ALARM Mode
True Motion Position sync.
Heading Line Blink
Ex. Monitor Horizontal Position 20 to 120
Ex. Radar Image Bearing Offset
Chapter 6
Operation Manual
Indication
XX HOURS
XX HOURS
Normal indication (range)
10 to 20
50 to 240
100 to 180
5 to 240
10 to 240
10 to 240
1
ID No. (See NOTE)
200 to 300
30 to 50
Selection
IN, OUT
OFF, ON
OFF, ON
-179.9 to 180.0
6-23