Installation Of The Ata Module, Mre-300; Installation Of The Ais Module, Ais-100 - Koden MDC-1840BB Operation Manual

MDC-1840BB/1841BB/1860BB/1810BB/1820BB Series
Operation Manual
APPENDIX 1

Installation of the ATA module, MRE-300

The ATA module MRE-300 is installed inside the display unit. Use the following the
instructions for installation.
(1) Locate the position of the four fixing studs on the Main Logic PCB (E47-700*)
prepared for the ATA module. (Refer to the figure below)
(2) Put the ATA module (MRE-300) on the studs and press the module gently
downwards in order that the connector installed on the module properly plugs into
the receptacle J705 on the Main Logic PCB.
(3) Fix the module using the four 3 mm fixing screws, prepared in the ATA module kit.

Installation of the AIS module, AIS-100

The AIS module (AIS-100) is installed inside the display unit. Use the following
instructions for installation.
(1) Locate the position of the four fixing studs on the Main Logic PCB (E47-700*)
prepared for the AIS module. (Refer to the figure below)
(2) Put the AIS module (AIS-100) on the studs and press the module gently
downwards in order that the connector installed on the module properly plugs into
the receptacle J716 on the Main Logic PCB.
(3) Fix the module using the four 3 mm fixing screws, prepared in the AIS-100 kit.
0093142122-11
J705 J705
MRE-300
Main Logic PCB
E47-700A
J716
AIS-100
Chapter 4
Installation
4-27