Vect Time (Selecting The Vector Time); Epa Symbols - Koden MDC-1840BB Operation Manual

MDC-1840BB/1841BB/1860BB/1810BB/1820BB Series
Using The Menu
VECT (Vector):
The vector time of a plotted target.
BRG (Bearing):
The bearing of a target, plotted in true or relative mode. The bearing display is
referenced to own ship.
DIST (Distance):
The distance of a target plotted from own ship.
UNRELIABLE PLOT DATA:
A warning that means the assigned target plot is old and not reliable, suggesting you
to update the plotting. When this display is shown, an audio alarm is activated. If you
leave the plot not updated for 15 minutes after the last update, all symbols and data
currently plotted will be deleted.
LIMIT CPA TCPA
This is a warning limit of CPA and TCPA. If the CPA and TCPA figures exceed the set
up limit the assigned warning symbols flash and the audio alarm sounds. Set the
warning limit with the RADAR/LIM CPA or TCPA menu.

6.6.6 VECT TIME (Selecting the Vector Time)

This function is used to set up the length of a vector that predicts the position of a
target after preset time. Set with the RADAR/TRUE (REL) VECT menu.

6.6.7 EPA symbols

Acquisition symbols
The symbol for the plotted target changes as follows according to the plotting status:
This symbol appears when a target is plotted for the first time.
This symbol appears when a target is plotted for more than two points. A
vector develops and the target data can be displayed when its target
number is assigned (highlighted).
93142122-07
Chapter 6
Operation Manual
6-27