Remote Display - Furuno FR-8045 Operator's Manual

1. OPERATION
1.45

Remote Display

You can use this radar as a remote display when you set [Input Source] to [Slave] on
the [Installation] sub menu. When this setting is done, the menu and display change
as described below. To display the radar image on the remote display, transmit from
the main radar.
Note: The message "Please turn to STBY-mode when you change this setting." ap-
pears when you switch the mode in transmission.
Unavailable menu items
The menu items not available with the remote display are shown in the table.
[Echo]
[Custom 1, 2, 3]
[Alarm]
[Tuning]
[System] - [Sector Blanks]
[System] - [Installation]
Display appearance
The display changes as shown in the following illustration.
Transmitting or standby display indications for remote display
Items unavailable with Function key F1, F2 and F3
• [Pulse Length] ([Echo] menu)
• [2nd-Echo Rejector] ([Echo] menu)
• [Watchman] ([Alarm] menu)
• [Tuning Mode] ([Tuning] menu)
Total TX time indication
The total TX time (TX TIME XXXXXX.XH) does not appear on the diagnostic test or
on the Normal standby display.
1-54
Menu
[Pulse Length], [2nd Echo Rejector]
[Pulse Length]
[Watchman]
All menu items are not accessible.
All menu items are not accessible.
[Antenna Rotation], [MBS Adjust], [Auto Install Setup],
[Total TX Time]
Shown when display
Pulselength
unit functions as
is not displayed.
remote display.
0.5
H D G
SLAVE
NM
0.125
OFFCENT(M)
C S 1
H U P
Unavailable menu item(s)
Tuning indicator
is not displayed.
TRAIL(T)
3 5 9 . 9 °
06MIN
ALM1_ACK
ALM2_OUT
WTC is not displayed.