Tuning - Furuno FR-8045 Operator's Manual

1. OPERATION
1.6

Tuning

In default, the radar receiver can be tuned automatically after you set the radar to TX.
If you require fine tuning in manual, do the following:
1. Transmit the radar and select the maximum range with the RANGE key.
2. Press the MENU key to open the menu.
3. Use
4. Use
5. Use
6. Use
7. Use
corner of the display. The best tuning point is where the tuning bar moves to a
maximum value. The vertical bar on the tuning bar shows the tuning voltage.
8. Press the ENTER key.
9. Press the MENU key to close the menu.
Note: If the automatic tuning does not give the correct tuning, run the [Tuning Init Ad-
just] again.
1-6
or to select [Tuning] and press the ENTER key.
Menu
Brill/Color
Tuning Mode
Display Manual Tuning
Echo Tuning Init Adjust
Custom 1
Custom 2
Custom 3
Alarm
Target Trails
Tuning
Others
Target [ENTER]: Enter
[MENU] Exit
Choosing a tuning mode
Tuning menu
or to select [Tuning Mode] and press the ENTER key.
Auto
Manual
Tuning Mode options
or to select [Manual] and press the ENTER key.
or to select [Manual Tuning] and press the ENTER key.
Manual Tuning setting window
or to adjust the tuning while you look at the tuning bar in the upper-right
TUNE MAN
Vertical bar
Tuning
: Auto
: 6.00V
[CANCEL/HL OFF]: Back
Tuning method (Manual)
Tuning bar