How To Select A Pulselength - Furuno FR-8045 Operator's Manual

1. OPERATION
1.18

How to Select a Pulselength

The pulselength in use appears at the upper-left position on the screen. The pulse-
lengths are set to each range scale and custom setup. You can change the pulse-
length on the 1.5 nm, 1.6 nm, 3 nm or 3.2 nm range with the following procedure.
Pulselength cannot be changed on other ranges. (You can change the pulselength on
the 2 nm or 4 nm range in the [Russian-River] mode.) Use a longer pulse when your
purpose is long range detection. Use a shorter pulse when the resolution is important.
Note: Press the CUSTOM key several times to activate the [Echo] menu until the [CS
1] (2, 3) indication (custom setting) disappears from the screen. See the illustration in
section 1.3.
1. Press the MENU key to open the menu.
2. Use
Brill/Color
Display
Echo
Custom 1
Custom 2
Custom 3
Alarm
Target Trails
Tuning
Others
Target
Choosing a pulse length
3. Use
4. Use
length indication at the upper-left corner changes according to your selection as
shown below.
1.5 nm or 1.6 nm (or 2 nm in the [Russian-River] mode): "SP" for [Short] pulse,
"MP" for [Long] pulse
3 nm or 3.2 nm (or 4 nm in the [Russian-River] mode): "MP" for [Short] pulse, "LP"
for [Long] pulse
5. Press the MENU key to close the menu.
1-20
or to select [Echo] and press the ENTER key.
Menu
Sea Mode
Auto Sea
Rain Mode
Auto Rain
A/C Auto
Pulse Length
Echo Stretch
Echo Average
Noise Rejector
[ENTER]: Enter
[MENU]: Exit
Echo menu
or to select [Pulse Length] and press the ENTER key
Pulse Length options
or to select [Short] or [Long] then press the ENTER key. The pulse-
Echo
: Manual
: Advanced
: Manual
: Moderate
: Off
: Short
: Off
: Off
: Off
[CANCEL/HL OFF]: Back
Short
Long