Connection Of Video Equipment/External Monitor/Remote Display - Furuno 1824C Installation Manual

4.2 Connection of Video Equipment/
External Monitor/Remote Display
The above units can be connected to the MODEL1824C/1834C/1934C/1944C/1954C and
GD-1920C by using the hole at the rear of the display unit. Remove the cover to use this
hole. After connecting, cover the hole with soft putty to seal.

Connection of Video equipment/External monitor/remote display

4.2.1 Connecting video equipment
The display unit can show the picture from a CCD camera, video recorder, etc. which
outputs composite signal in NTSC/PAL format, by using the optional NTSC/PAL interface kit.
Necessary parts
Name: NTSC/PAL Interface kit
Type: OP03-175
Code no.: 008-523-070
Name
PIP board
Pan head screw
Connector assy
Cable tie
Rubber grommet
Video recorder, CCD camera etc.
12:00
VGA monitor
Remote display (ex. FMD-811)
Contents of NTSC/PAL Interface kit
Type
19P1004
M3x6 C2700W
RCA-TMP-L230
SG-130
MG-4
4-4
CAUTION
Even though the display
unit meets waterproof
standard IPX-5,
this modification can
affect waterproofness.
Watertight integrity
cannot be guaranteed.
Code No. Qty
NTSC/PAL
008-521-890 1
interface Board
000-881-403 4
000-144-615 1
000-809-171 3 w/foot for fixing
000-871-378 1
Remarks