Furuno FR-8045 Operator's Manual page 60

1. OPERATION
3. Use
4. Press the CANCEL/HL OFF key to close the alarm status display.
5. Press the MENU key to close the menu.
Alarm category
SIGNAL MISSING*
"TRIGGER"
"HEADING"
"BEARING"
"GYRO"
"VIDEO"
"POSITION"
"NMEA_HDG"
TARGET ALARM1(2)
"IN"
"OUT"
ARPA ALARM
"COLLISION"
"LOST"
"PROXIMITY"
AIS ALARM
"COLLISION"
"PROXIMITY"
AIS SYSTEM*
"TX"
"FAIL"
"ANT"
"CH1"
"CH2"
"CH70"
"MKD"
"EPFS"
"L/L"
"SOG"
Continued on following page
1-46
or to select [Alarm Status] and press the ENTER key.
Alarm Status
TRIGGER HEADING BEARING GYRO
[SIGNAL MISSING]
VIDEO POSITION NMEA_HDG
[TARGET ALARM1]
IN OUT
[TARGET ALARM2]
IN OUT
[ARPA ALARM]
COLLISION LOST PROXIMITY
[AIS ALARM] COLLISION PROXIMITY
[AIS SYSTEM] TX ANT CH1 CH2 CH70 FAIL MKD
EPFS L/L SOG COG HDG ROT
[OTHER] OVER_TEMP
[CANCEL/HL OFF]: Close
Trigger signal lost (only for remote display)
Heading signal lost
Bearing signal lost
AD-10 format gyro signal lost
Video signal lost
NMEA format position data lost
NMEA format heading signal lost
An echo has entered a target alarm zone.
An echo has exited a target alarm zone.
CPA and TCPA of an ARPA target are less than CPA and
TCPA alarm settings.
The acquired ARPA target becomes lost.
The range to an ARPA target is less than the user-set
proximity alarm range.
CPA and TCPA of an AIS target are less than CPA and
TCPA alarm settings.
The range to an AIS target is less than the user-set prox-
imity alarm range.
TX stopped or TX error
System failure
Antenna VSWR problem
TDM2 RX1 board problem
TDM2 RX2 board problem
RX channel 70 problem
Minimum input device lost
Navigator (GPS, etc.) problem
Position data lost
Speed data lost
Meaning