Installing The Hot-Swap Power-Supply Cage Assembly - IBM x3400 7975 Problem Determination And Service Manual

Installing the hot-swap power-supply cage assembly

To install the hot-swap power-supply cage assembly, complete the following steps.
1. Align the screw holes on the power-supply cage pivot bracket with the
2. Press the power-supply cage release tab and rotate the power-supply cage
corresponding screw holes on the rear of the chassis. Support the cage while
you install the three screws to secure the pivot bracket on the power-supply
cage to the chassis.
Power supply
retaining screws
Power supply
assembly
assembly into the chassis until it locks in place.
Chapter 4. Removing and replacing server components
145