Installing The Fork Legs; Removing The Fork Protector - Husqvarna 125 TC EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.8

Installing the fork legs

11.9

Removing the fork protector

x
Main work
–
Position the fork legs.
Bleeder screws
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the upper
triple clamp.
L01910-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
L01911-11
–
Position the brake caliper and mount and tighten screws
Guideline
Screw, front brake caliper
–
Position the brake line. Put the clamp on and mount and tighten screws
800191-11
Finishing work
–
Install the front wheel.
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
Main work
–
Remove screws
–
Remove the screws on the right fork leg. Lift off the fork protector.
B00306-10
1
face forward.
2
.
3
.
M8
( p. 65)
x
( p. 65)
x
( p. 34)
x
1
on the left fork leg. Lift off the fork protector.
M8 17 Nm (12.5 lbf ft)
M8 12 Nm (8.9 lbf ft)
4 .
25 Nm Loctite
(18.4 lbf ft)
p. 33)
35
® 243™
5 .