Changing The Hydraulic Clutch Fluid - Husqvarna 125 TC EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.49

Changing the hydraulic clutch fluid

Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
x
(125 TC EU)
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
L00953-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Hydraulic oil (15) (
–
On the slave cylinder of the clutch, remove bleeder screw
ing syringe
L01921-10
–
Inject the liquid into the system until it escapes from bore hole
cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level under top level of container
–
Position the cover with the membrane. Mount and tighten the screws.
L00953-11
(250 TC EU)
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
L01222-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the slave cylinder of the clutch, remove bleeder screw
ing syringe
L01800-10
1
.
2 3
with membrane .
4
with the appropriate hydraulic fluid.
p. 100)
4 .
1 .
2 3
with membrane .
4 with the appropriate hydraulic fluid.
p. 100)
4
.
5
and mount bleed-
6
of the master
4 mm (0.16 in)
5
and mount bleed-
54