Husqvarna 125 TC EU Owner's Manual page 65

12 BRAKE SYSTEM
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule. (Your authorized Husqvarna workshop
will be glad to help.)
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents Reduced braking efficiency due to the use of non-approved brake linings.
–
Brake linings available in accessories stores often have not been tested and approved for use in Husqvarna vehicles. The
structure and fiction coefficient of the brake linings and thus their brake power may vary greatly from that of original Husq-
varna bake linings. If brake linings that differ from the original equipment are used, it cannot be guaranteed that these are in
keeping with the original homologation. In this case, the vehicle will not correspond to its condition at delivery and the war-
ranty shall be void.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5 brake
fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
–
Stand the vehicle upright.
–
Remove screw cap
B01904-10
–
Manually press the brake caliper to the brake disc to push back the brake piston.
Ensure that brake fluid does not flow out of the brake fluid reservoir, extracting it by
suction if it does.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
–
Remove cotter pins
–
Clean the brake caliper and brake caliper support.
B01906-10
–
Check that leaf spring
caliper support are seated correctly.
Info
The arrow on the leaf spring points in the rotation direction of the brake disc.
L00194-10
1 with membrane 2 and the O-ring.
3 4
, pull out pin , and remove the brake linings.
5
in the brake caliper and sliding plate
63
6
in the brake