Removing The Seat; Mounting The Seat; Removing The Air Filter Box Lid; Installing The Air Filter Box Lid - Husqvarna 125 TC EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.22

Removing the seat

11.23

Mounting the seat

11.24

Removing the air filter box lid

11.25

Installing the air filter box lid

11.26

Removing the air filter

Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
–
Never operate the vehicle without an air filter as dust and dirt will enter the engine and lead to increased wear.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Remove screws
–
Raise the rear of the seat, push the seat back, and lift it off.
B01819-10
–
Hook in the front of the seat at the collar bushing of the fuel tank, lower at the rear
and simultaneously push forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screws for securing the seat.
Guideline
Remaining screws, chassis
L01630-01
–
Release catch
remove toward the rear.
L01918-10
–
Position the air filter box lid and catch
B
and .
–
Engage catch
L01918-10
x
Preparatory work
–
Remove the air filter box lid. (
1
in the recessed grips on the left and right.
1
, pull off the air filter box lid sideways in areas
1
. Engage the air filter box lid in areas
1 .
p. 42)
M6 10 Nm (7.4 lbf ft)
A
and
42
B
, and
A