Checking The Rubber Grip; Additionally Securing The Rubber Grip; Adjusting The Basic Position Of The Clutch Lever - Husqvarna 125 TC EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.45

Checking the rubber grip

11.46

Additionally securing the rubber grip

11.47

Adjusting the basic position of the clutch lever

(250 TC EU)
–
Check the routing of the throttle cable.
The throttle cable must be routed along the back of the handlebar, to the right
of the frame, below the fuel tank bracket, and to the carburetor.
» If the throttle cable is not routed as specified:
–
L01809-10
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
–
Check the rubber grips on the handlebar for damage and wear and to ensure they
are firmly seated.
» If a rubber grip is damaged, worn, or loose:
–
Change and secure the rubber grip.
Rubber grip adhesive (00062030051) (
401197-01
Preparatory work
–
Check the rubber grip. (
Main work
–
Secure the rubber grip at two points using the securing wire.
Securing wire (54812016000)
Wire twister forceps (U6907854)
The twisted wire ends face away from the hands and are bent toward the rubber
grip.
401198-01
(125 TC EU)
–
Adjust the basic setting of the clutch lever to your hand size by turning adjusting
1
screw
L01907-11
Correct the routing of the throttle cable.
( p. 46)
x
p. 42)
p. 52)
.
p. 102)
52