10
TUNING THE CHASSIS
10.14
Handlebar position
10.15
Adjusting the handlebar position
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handlebar.
On the upper triple clamp, there are two holes a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
The handlebar can be mounted in four different positions. In this way, the handlebar can
be mounted in the position that is most comfortable for the rider.
B00025-11
x
–
Remove screws
to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar support in the required position. Mount and tighten screws
B00375-10
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap widths are even.
15 mm (0.59 in)
3.5 mm (0.138 in)
1
. Remove the handlebar clamp. Remove the handlebar and lay it
2
. Remove the handlebar support.
M10
M8
A
apart.
B
from the center.
40 Nm
Loctite
®
(29.5 lbf ft)
1
and tighten evenly.
20 Nm (14.8 lbf ft)
32
2
.
243™