Removing The System Management Board Cover - Lenovo ThinkServer sd350 Installation And Service Manual

Step 3. Hold the front of the server and slide the cover forward to the closed position, until it clicks into
place.
Step 4. Tighten the cover with the 3 M3 screws.
Step 5. To install a system service label (which needs to be ordered separately), align the label on the
cover, remove the backing, and press the label on the cover.

Removing the system management board cover

Use this information to remove the cover from a system management board.
Before you remove the system management board cover, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 75.
2. Turn off the server (see "Turning off the server" on page 29 for instructions) and all attached peripheral
devices. Disconnect all power cords; then, disconnect all external cables as necessary to replace
the device.
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
Statement 12
CAUTION:
The following label indicates a hot surface nearby.
84
Lenovo ThinkServer sd350 Server Type 5493, Lenovo ThinkServer n400 Enclosure Type 5495Installation and Service Guide
Screws
Guide pin