Volume Deletion - Overland Storage SnapServer Administrator's Manual

SnapServer GuardianOS 7.2 Administrator's Guide
2. Click the volume name in the table.
3. At the Volume Properties page, change the options desired:
• Edit the volume name using up to 32 alphanumeric characters and spaces.
• Specify the maximum size of the volume:
4. When you are done, click OK.

Volume Deletion

To delete a volume, click the Delete button on the Storage > Volumes page.
To Delete a Volume
1. Navigate to Storage > Volumes.
2. Click the volume name in the table.
3. At the Volume Properties page, click Delete Volume.
4. At the confirmation page, click Delete Volume again.
You are returned to the Volumes page. The volume is deleted in the background.
10400317-003 05/2012
• No Limit – this allows the volume to expand as needed incorporating the
remaining unused space on the storage pool.
• Maximum size – Establish a maximum volume size limit by entering the
amount and selecting a unit of measure. The volume then grows in size until it
reaches its maximum. If email notification has been enabled, alerts are sent as
the maximum is approached. (To enable email notification, see
Notification" on page
NOTE: If you set the maximum size to less than the current size, the volume is treated as
full and no more data can written to it until the actual space consumed is below the
maximum size again.
Deleting a volume deletes all data on the volume.
CAUTION:
©2010-12 Overland Storage, Inc.
9-15.)
Volumes
"Email
 4-12