Overland Storage SnapServer Administrator's Manual page 227

SnapServer GuardianOS 7.2 Administrator's Guide
2. You are placed into the CLI shell. However, a standard Linux shell must be used to
install the agent. To launch a shell, type the following command and press Enter:
osshell
3. To change to superuser, enter the following command, and press Enter:
su -
4. At the prompt, enter the admin user password, and press Enter.
5. Use the
cd /shares/SHARE1/agent
6. To unpackage the client files, enter the following commands:
tar xvfz nw_linux86.tar.gz
7. To install the NetWorker Agent rpm, enter the following command:
rpm -Uvh --nodeps --relocate=/usr/=/hd/vol_mnt[X]/NetWorker/usr/
lgtoclnt-x.x-x.i686.rpm
where
version number.
8. To start the EMC NetWorker daemon, enter the following command at the console:
/etc/rc.d/init.d/networker start
The NetWorker client is now installed.
9. Close the SSH client, return to the Web Management Interface. To start the newly
installed backup agent, navigate to the Maintenance > Shutdown/Restart page, and
click Restart.
10. Delete the client files you copied to the SnapServer because they are no longer needed.
11. To verify the success of the installation, use your backup management software to
configure and run a test backup.
Backup and Restore Operations with the EMC NetWorker Client
This section describes special procedures EMC NetWorker users must use in order to
perform backup and restore operations on the SnapServer.
Add the SnapServer as a Root User
For backup operations, NetWorker requires that the SnapServer be configured as a root
user. To add the SnapServer root user as one of the administrators, use the following
procedure:
1. Open the NetWorker Administrator application.
2. Click the Configuration tab.
3. Click the User Groups menu item.
4. Click the Administrators group.
5. In the Configuration box, add one of the following:
user=root@hostname
where
Or, enter:
user=root
to add root for all SnapServers.
6. Click OK.
10400317-003 05/2012
command to change to the directory in the share, for example:
cd
is the NetWorker installation target volume and
vol_mnt[X]
is the host name of the SnapServer for each SnapServer.
hostname
©2010-12 Overland Storage, Inc.
Off-the-Shelf Backup Solutions
is the
x.x-x
 B-12