Overland Storage SnapServer N2000 Quick Start Manual

This document describes how to unpack a SnapServer N2000
from Overland Storage and install it into a four-post, 32-inch
deep, 19-inch (EIA-310) rack. The N2000 comes with four empty
drive slots and the remaining eight slots filled with drive blanks.
It must be populated with four to twelve drives to be operational.
WARNING: To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working with
the unit.
AVERTISSEMENT: Pour réduire le risque de choc électrique ou
endommagement de l'équipement, retirez toujours les cordons
électriques en travaillant avec l'appareil.
CAUTION: While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage to
micro-circuitry or static-sensitive devices.
Step 1: Activate Your Warranty!
It is essential that you activate your warranty. Technical and
warranty support are not available until it is done:
1. Note the product serial number from the box label or on the
product.
2. Go to the Overland Storage web site:
http://www.overlandstorage.com/
Select
3.
Service & Support > My Products.
4. At the Site Login, enter your e-mail address and
password, and click GO.
5. Click Register New Product.
6. Fill in the information and click Submit.
IMPORTANT: Within three business days, you'll receive an e-mail
from Overland with your warranty certificate. Follow the
instructions included to complete the process.
Step 2: Install Unit in Rack
WARNING: Use care during rack installation or removal to
prevent accidental tipping of the rack causing damage or
personal injury.
AVERTISSEMENT: soyez prudent lors de l'installation ou de
l'enlèvement du support afin d'empêcher le renversement
accidentel de la crémaillère, pour éviter dommages et blessures.
10400287-002 03/2011
SnapServer
©2010-11 Overland Storage, Inc.
Quick Start Guide
®
N2000
Enter
Enter
Page 1 of 7