Insufficient Paper For Job - Canon iPF755 User Manual

Because the Platen is soiled with ink or other substances, the size of
the clear film cannot be detected.

Insufficient paper for job

The printer has received a print job longer than the amount of roll pa-
per left when ManageRemainRoll in the Control Panel menu is On.
iPF755
Cause
Cause
Error Message > Messages regarding paper
Corrective Action
4. If "Not finished printing. Finish print-
ing remaining jobs?" is shown on the
Display Screen, press the OK button.
Printing will resume, starting from the
page on which the error occurred.
(See "Loading Rolls in the Printer.")
→P.588
If this error recurs after you reload the roll,
remove the Roll Holder from the printer,
push the roll firmly in until it touches the
Roll Holder flange, and reload the Roll
Holder in the printer.
(See "Attaching the Roll Holder to Rolls.")
→P.585
Follow these step to reload a sheet.
1.
Push the Release Lever back.
2. Load the sheet, aligning it with the guide
on the right.
3.
Pull the Release Lever forward.
4. If "Not finished printing. Finish print-
ing remaining jobs?" is shown on the
Display Screen, press the OK button.
Printing will resume, starting from the
page on which the error occurred.
(See "Loading Sheets in the Printer.")
→P.609
Open the Top Cover and clean the entire
Platen.
(See "Cleaning Inside the Top Cover.")
→P.757
Corrective Action
Press ▲ or ▼ to select Print, and then
press the OK button to resume printing.
However, the roll paper may run out dur-
ing the print job and you may not be able
to print all of the document.
Press ▲ or ▼ to select Change Paper,
and then press the OK button to stop
printing.
Either change the printer driver Paper
Source setting or the GL2 Settings > Pa-
per Source setting in the printer menu or
replace the roll with a roll that has
enough paper for the print job, and then
try printing again.
(See "Removing the Roll from the
Printer.")
→P.594
(See "Loading Rolls in the Printer.")
→P.588
Insufficient paper for job
>
13
807