Canon iPF755 User Manual page 646

Adjustments for Better Print Quality
Note
• Always check the Adj. Priority values before using Auto(GenuinePpr) or Auto(OtherPaper).
(See "Selecting a Feed Amount Adjustment Method (Feed Priority).")
• Adjustment is not possible with Auto(GenuinePpr) and Auto(OtherPaper) when using highly transpar-
ent media.
In this case, use Manual adjustment.
(See "Manual Banding Adjustment (Adj. Quality).")
• If additional fine-tuning is necessary after Auto(GenuinePpr) and Auto(OtherPaper), execute Adj.
Fine Feed.
(See "Fine-Tuning the Paper Feed Amount (Adj. Fine Feed).")
• Use Adjust Length to ensure that lines in CAD drawings are printed at exactly the right length.
(See "Adjusting Line Length (Adjust Length).")
• This may take some time, depending on the type of paper.
• Use paper of the same type and size for adjustment as you will use for printing.
Paper to Prepare
Rolls
Sheets
Perform adjustment as follows.
1.
Load the paper.
8
• Attaching the Roll Holder to Rolls
• Loading Rolls in the Printer
• Loading Sheets in the Printer
2.
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab (
630
3.
Press the OK button.
The Set./Adj. Menu is displayed.
4.
Press ▲ or ▼ to select Adjust Printer, and then press the OK button.
5.
Press ▲ or ▼ to select Feed Priority, and then press the OK button.
6.
Press ▲ or ▼ to select Adj. Quality, and then press the OK button.
Automatic Banding Adjustment (Adj. Quality)
> Adjusting the feed amount
An unused roll at least 10 inches wide
Auto(GenuinePpr) : One sheet of unused paper of at least A4/Letter size
Auto(OtherPaper) : Two sheets of unused paper of at least A4/Letter size (or one sheet when using A2 or
larger)
→P.588
Note
• Always make sure the loaded paper matches the type of paper specified. Adjustment cannot be
completed correctly unless the loaded paper matches the settings.
Note
• If the Tab Selection screen is not displayed, press the Menu button.
>
→P.631
→P.633
→P.585
→P.609
→P.628
→P.633
).
iPF755