Configuring Tcp/Ipv6 Network Settings; Using Remoteui - Canon iPF755 User Manual

Configuring TCP/IPv6 Network Settings

When printing in a TCP/IPv6 network, you must configure the TCP/IPv6 settings on the Control Panel.
Follow the steps below to configure the TCP/IPv6 network settings.
1.
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab (
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2.
Press the OK button.
The Set./Adj. Menu is displayed.
3.
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4.
Press ▲ or ▼ to select TCP/IP, and then press the OK button.
5.
Press ▲ or ▼ to select IPv6, and then press the OK button.
6.
Press ▲ or ▼ to select IPv6 Support, and then press the OK button.
7.
Press ▲ or ▼ to select On, and then press the OK button.
Important
• Once you set IPv6 Support to On, the IPv6 StlessAddrs setting takes effect.
• You can also configure IPv6 StlessAddrs and DHCPv6 from the printer Control Panel.

Using RemoteUI

Enter the printer's IP address in a web browser to display the RemoteUI page. After you log on to RemoteUI from the
page, you can check and change the status of the printer and print jobs, and configure network settings.
To access RemoteUI, start the web browser and enter the following URL in the Location (or Address ) box to display
the RemoteUI page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
For details on configuring printer settings for networks, refer to the following topics.
• Configuring the Printer's TCP/IP Network Settings
• Configuring the Printer's AppleTalk Network Settings
• Configuring the Printer's NetWare Network Settings
• Specifying Printer-Related Information
iPF755
→P.708
→P.726
→P.716
→P.711
Network Setting > Network Setting
Configuring TCP/IPv6 Network Settings
>
).
10
707