Insufficient Paper For Job; This Paper Cannot Be Used; Roll Printing Is Selected - Canon iPF670 User Manual

iPF670
Cause
Paper has been loaded
askew, or warped paper
has been loaded.

Insufficient paper for job

Insufficient paper for job

The printer has received a print job longer than the amount of roll paper left when
ManageRemainRoll in the Control Panel menu is On.

This paper cannot be used.

This paper cannot be used.
Cause
Paper smaller than the printer's minimum supported
size has been loaded.
Paper has been loaded that is too small to print the test
pattern for printhead adjustment or nozzle checking.

Roll printing is selected.

Roll printing is selected.
Cause
You have attempted to print on a roll, but
no roll is loaded.
User's Guide
2.
Pull the Release Lever forward.
3.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the
OK button.
Printing will resume, starting from the page on which the error occurred.
If this error recurs after you reload the roll, remove the Roll Holder from the printer, push the roll firmly in until
it touches the Roll Holder flange, and reload the Roll Holder in the printer.
(See "Attaching the Roll Holder to Rolls.")
Follow these step to reload a sheet.
1.
Push the Release Lever back.
2.
Load the sheet, aligning it with the guide on the right.
(See "Loading Sheets in the Printer.")
3.
Pull the Release Lever forward.
4.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the
OK button.
Printing will resume, starting from the page on which the error occurred.
Cause
Push the Release Lever back and load paper of the correct size.
(See "Paper Sizes.")
Push the Release Lever back and load unused paper of A4 size or larger.
More than one sheet may be required depending on the adjustment.
Press ▲ or ▼ to select "Load Roll Paper", and then press the OK button. Load the roll, and
then print.
(See "Attaching the Roll Holder to Rolls.")
Corrective Action
P.354
➔
P.375
➔
Press ▲ or ▼ to select Print, and then press the
OK button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of
the document.
Press ▲ or ▼ to select Change Paper, and then
press the OK button to stop printing.
Either change the printer driver Paper Source
setting or the GL2 Settings > Paper Source set-
ting in the printer menu or replace the roll with a
roll that has enough paper for the print job, and
then try printing again.
(See "Removing the Roll from the Print-
er.")
P.362
➔
(See "Loading Rolls in the Printer.")
Press ▲ or ▼ and select Stop Printing or press
the Stop button to stop printing.
Corrective Action
P.344
➔
Corrective Action
P.354
➔
Insufficient paper for job
Corrective Action
P.357
➔
613