Table of Contents
Advertisement
MAINTENANCE
WARNING: You will need to lubricate your treadmill before the first use.
RUNNING BELTS & TREADMILL LUBRICANT:
Lubricating the running board and running belt is essential as the friction between the two affects
the life span and function of the treadmill, therefore it is suggested that the running board and belt
be inspected regularly.
SILICON OIL:
The treadmill has been coated with Silicone Oil during construction. Silicone oil is a non-volatile
oil.
To maintain the belt, "Silicone Oil" may be re-applied once the resistance has been increased and
the belt starts rubbing against the walking deck. To re-apply the Silicone Oil to the treadmill, lift up
the belt, one side at a time, and apply the oil directly to the center of the walking deck. Allow the
silicone oil to 'set' for one minute before using the treadmill.
Attention: Only use "Silicone Oil" lubricants for this equipment. In addition, do not add any other
type of oil; otherwise the treadmill will be damaged. Do not over-lubricate the walking board.
Excess lubricant should be wiped off with a clean towel.
WARNING: To prevent electrical shock, turn off and unplug the treadmill before cleaning or
performing routine maintenance.
CLEANING
The treadmill should be cleaned with a soft cloth and mild detergent. Do not use abrasives or
solvents. Be careful not get excessive moisture on the display panel as this will cause an electrical
hazard or the electronics to fail. Keep the treadmill, especially, the console, out of direct sunlight to
prevent screen damage and paint discoloration.
19
Advertisement
Table of Contents
