Trouble Shooting - Exerpeutic 1020H Owner's Manual

Fault Code
SAFE Safety tether key protection
Computer receiving error
Er1
signal up to 15 seconds.
Er3
1.Motor Cable become loose
Er5 2.Motor is blocked
3.Motor damaged
Power IC board not receiving
Er7
TROUBLESHOOTING
Error Codes Cause and Solutions
Cause
Low Voltage
signal
1. Ensure that the Safety Tether Key is installed on the
Computer (57).
2.Restart the power after 1 minute and install the Safety
Tether Key
3. Computer IC Board damaged, Contact Customer
Service.
1.Restart the power, and retry after 1 minute
2.Ensure the sensor cable is connected perfectly
3.Signal cable or computer IC board damaged,
Discontinue use and contact Customer Service
1. Restart the power and retry after 1 minute. Check if
the input voltage is lower. Use when voltage is normal
2.Signal Cable or power IC board damaged, Discontinue
use and contact Customer Service
1. Restart the power, and retry after 1 minute
2.Check the motor cable , make sure it is connect
perfectly
3.Check the motor quality, make sure there is no visible
damage.
4.Ensure the running belt is thoroughly lubricated.
5.Motor or power IC board damaged, Discontinue use
and contact Customer Service
1. Restart the power, and retry after 1 minute
2.Ensure that the sensor cable is connected perfectly
3. Signal cable or power IC board damaged, Discontinue
use and contact Customer Service
25
Solution