Exerpeutic 1000 Owner's Manual page 10

ASSEMBLY
Step 2
Remove the Round Knob (24) from the Stabilizer (4).
Place one hand on the rear end of Main Frame (1) and use the other hand to
pull out the Ball Knob (25). Lower the Main Frame (1) down onto the floor.
TO PREVENT INJURY PLEASE MAKE SURE YOU HAVE A FIRM HOLD
WHEN SETTING DOWN THE DECK.
Remove two Computer Knobs (31) from the Computer Support Plate (7).
Remove two Handlebar Knobs (28) from the Handlebar (5) and then lift the
Handlebar (5) all the way up.
Tighten the Handlebar (5) onto the Stabilizer (4) with two Handlebar Knobs
(28) that were removed.
Turn the Computer (6) upwards and adjust the angle of Computer (6) to the
desired position. Hold the Computer (6) and align computer knob holes.
Tighten the Computer (6) onto the Handlebar (5) with two Computer Knobs
(31) that were removed.
9