Storage - Exerpeutic 1000 Owner's Manual

Round Knob (24) shall be positioned here
when Main Frame (1) is lifted up in the
upright position.
Remove Round Knob (24) from the Stabilizer (4) and Main Frame (1).
Hold the rear end of the Main Frame (1) by one hand and use the other hand
to pull out the Ball Knob (25). Lift the Main Frame (1) up and align spring
knob pin hole. Release the Ball Knob (25) until the Spring Knob Pin (26)
pop into the hole on the Main Frame (1) to lock the Main Frame (1) in place.
CAUTION: Failure to secure the Main Frame (1) with the Spring
Knob Pin (26) may cause the treadmill accidental fall and cause
bodily injury.
Install the Round Knob (24) onto the Main Frame (1).
Remove two Handlebar Knobs (28) from the Handlebar (5) and then push
the Handlebar (5) all the way down.
Install two Handlebar Knobs (28) back onto the Handlebar (5) to lock the
Handlebar (5) in place.
Remove two Computer Knobs (31) from the Computer Support Plate (7).
Turn the Computer (6) downwards and align computer knob holes.
Tighten the Computer (6) onto the Handlebar (5) with two Computer Knobs
(31) that were removed.

STORAGE

12