Communication Setup Menu - Sony Ipela PCS-XG80S Operating Instructions Manual

of 720p (1280 × 720 pixels) in H.264
Video Mode when "Voice Activate"
mode is activated.
Notes
• The "Voice Activate (720P)" mode cannot
be selected when the communication is made
via an ISDN or SIP connection. Even for an
IP connection, this mode is not available if
the remote party does not support H.264
Video Mode.
• When "Broadcast Mode" is set to "Voice
Activate (720P)", you cannot change
"Broadcast Mode" during communication.
Select the Broadcast Mode before starting
communication.
Split
Allows you to select the type of split display
used to display local and remote pictures on
a single monitor during a multipoint
connection.
Automatic: When there are two or three
terminals connected, the display is
automatically split into four parts. When
there are four or five terminals
connected, it is split into six parts.
Six-screen Mosaic: The display is split into
six parts regardless of the number of
terminals connected.
Note
When there is only one terminal connected, the
display switches to full screen regardless of the
selection of the setting.

Communication Setup Menu

The Communication setup menu is used to
set up communications.
Note
The contents of the Communication menu vary
with "Line Interface" setting in the Line I/F
setup menu, or "Individual Settings for
Transmission/Reception" or "Individual
Settings for Point-to-Point/Multipoint" setting
in the Communication setup menu.
The Communication page number after the
Communication2 page also varies according to
the number of setting items.
66
Registering Local Information
Communication
IP
The menu is used to set up the
communication mode for the IP connection.
Individual Settings for Transmission/
Reception
Allows you to select whether to configure
the IP settings for transmission and
reception individually.
Off: Select to configure the IP settings for
transmission and reception commonly.
On: Select to configure the IP settings for
transmission and reception individually.
Individual Settings for Point-to-Point/
Multipoint
Allows you to select whether to configure
the IP settings for a point-to-point
connection and multipoint connection
individually.
Off: Select to configure the IP settings for
both connections commonly.
On: Select to configure the IP settings for a
point-to-point connection and
multipoint connection individually.
Note
The setting items and page numbers in the IP:
Mode page vary according to the setting of
"Individual Settings".
Communication
IP: Mode
Total Bandwidth
Allows you to select the total bandwidth to
be used with this system.
In multipoint connection, the total
bandwidth of all points is displayed.
You can select from among 128Kbps,
384Kbps, 512Kbps, 1Mbps, 2Mbps, 3Mbps,
4Mbps, 5Mbps, 6Mbps, 7Mbps, 8Mbps,
9Mbps, 10Mbps and Other.
Note
In multipoint connection, the actual
Communication Bit Rate for each point is
automatically adjusted so as not to exceed
"Total Bandwidth".