Video Setup Menu - Sony Ipela PCS-XG80S Operating Instructions Manual

Dial Tone
Allows you to select the volume of a ring-
back and busy tones when you are dialing
from among "Loud", "Medium" and
"Quiet". You can also select "Off" for the
ring-back and busy tones not to be output.
Ringer Tone
Allows you to select the volume of a ring
tone when you receive a call from among
"Loud", "Medium" and "Quiet". You can
also select "Off" for the ring tone not to be
output.

Video Setup Menu

The Video setup menu is used to set up video
input/output.
Video1
Basic Setup
Video Input
Allows you to select the video input.
Camera: Selects the camera picture from
the camera connected to the CAMERA
connector.
RGB: Selects the video signal from the
external equipment connected to the
RGB IN connector.
YPbPr: Selects the video signal from the
external equipment connected to the
VIDEO IN YPbPr connector.
S-VIDEO: Selects the video signal from the
external equipment connected to the S
VIDEO IN connector.
Presentation Screen
Allows you to select the display pattern of
the presentation screen.
Full Screen: Displays the computer picture,
etc. from the external equipment
connected to the RGB IN connector in
full screen mode.
PandP: Displays the computer picture, etc.
from the external equipment connected
to the RGB IN connector and the
selected input picuture such as a camera
picture in PandP mode.
Side by Side: Displays the computer
picture, etc. from the external equipment
connected to the RGB IN connector and
72
Registering Local Information
the selected input picture such as a
camera picture in Side by Side mode.
Monitor Output
Allows you to select the video signal output
from the Communication System.
HDMI: Outputs the video signal to the
external equipment connected to the
HDMI OUT connector.
RGB: Outputs the video signal to the
external equipment connected to the
RGB OUT connector.
HDMI+RGB: Outputs the video signal to
the external equipment connected to the
HDMI OUT and RGB OUT connectors.
Notes
• If "Monitor Output" is set to "HDMI+RGB"
when no HDMI monitor is connected to the
Communication System, you cannot view
the menus. Before making this setting, be
sure to connect an HDMI monitor.
• When you change the setting of "Monitor
Output" to an incorrect setting, no picture is
displayed on the screen. In this case, select
the correct setting for "Monitor Output"
? 1
using the / (power) switch on the
Communication System and the buttons on
the Remote Commander.
? 1
When the / (power) indicator on the
Communication System stays lit, perform
the steps below.
? 1
1
Press the / (power) switch on the
Communication System.
2 Within five seconds after you pressed the
? 1
/ switch, press the buttons on the
Remote Commander described below
depending on the desired "Monitor
Output".
HDMI: VIDEO INPUT button (once)
then Number button 3 (three times)
RGB: VIDEO INPUT button (once) then
Number button 4 (three times)
HDMI+RGB: VIDEO INPUT button
(once) then Number button 5 (three
times)
The setting of "Monitor Output" is changed,
and the picture will be displayed on the screen.
RGB Monitor Output Format
Allows you to select the format of the signal
output from the RGB OUT connector.
SXGA: Outputs the SXGA signal.