To pair the Communication System with the Remote Commander again
Follow the procedure below to release the paring with the Camera Unit, and to
perform pairing with the System again.
1
Turn on the Communication System.
2
Set "RF Remote Control Reception" to "System" on the Device Setup page
of the General setup menu (page 81).
3
Within three minutes after the power is on, locate the Remote Commander
closer to the Communication System, and press the RETURN and TOOLS
buttons at the same time.
The LED indicator flashes rapidly.
4
Press the ENTER button on the Remote Commander.
If the LED indicator flashes more slowly, pairing between the units has
succeeded.
Preparing the System
39