Kubota M100GX Operator's Manual page 171

Selected
Info
screen
Work
B
area
Selected
Info
screen
Travel
distance
Instantaneous loading factor
Average loading factor
Loading
factor
Instantaneous loading factor graph
Time
C
Clock
Date
DPF
tempera-
ture
PM buildup
PM
buildup
PM buildup graph
Blank
*1: In the various setting mode, preset the "Working range of implement". (Refer to the "Initial Setting" in "SIDE DIGITAL
DISPLAY" in "OPERATING THE TRACTOR" section.) If not preset, correctly, incorrect data will be displayed.
Display
A Displays the work area measured from the
A Hold down the corresponding switch. The setting
A (See *1.)
Display
A Displays the travel distance measured from the
A Hold down the corresponding switch, and the
A Each time the corresponding switch is pressed, the
A The "average" is measured based on the loading
A With the "average" displayed, hold down the
A The
A Shows the standard factory settings. Refer to the
A Displays the DPF muffler temperature.
A Displays the PM buildup inside the DPF muffler.
A Regeneration is needed when the 100% level has
A Each time the corresponding switch is pressed, the
A The more the bar is extended to the right, the more
A Used to delete the information displayed.
Remarks
previous resetting.
goes back to "0.0".
Remarks
previous resetting.
setting goes back to "0".
"instantaneous", "average"
displayed alternately in this order.
factor from the previous resetting.
corresponding switch. The setting goes back to
"0".
"instantaneous loading
graphically displays the instantaneous loading
factor in real time. (The more the bar is extended
to the right, the higher the load becomes.)
"Handling the side digital display" section.
been reached.
"numerical value" and "graph" are displayed
alternately.
PM builds up.
APPENDICES 149
Ref.
page
-
Ref.
page
-
and "graph" are
-
-
factor graph"
-
42
152
14
14
14
-