Cleaning Fuel Solenoid Pump Element - Kubota M100GX Operator's Manual

(1) O ring
(2) Element
(3) Element cup
(4) Red float
(5) Cup
(6) Drain plug
(1) O ring
(2) Element
(3) Red float
(4) Cup
(5) Drain plug
A If the water separator and/or fuel filter is not well
maintained, the supply pump and injector may be
damaged earlier than expected.
BCleaning Fuel Solenoid Pump Element
[M126GX, M135GX]
1. Close the fuel cock.
2. Unscrew the cover's nut and remove the cover from
the fuel solenoid pump.
3. Remove the cover, magnet, and element and clean
with kerosene.
4. Refer to the diagram below and reassemble the parts
as they were before.
5. Open the fuel cock.
A When assembling the parts, be careful that no dirt or
dust contacts them.
A Be sure to install the cover securely.
A After assembly, be sure to bleed the air from the fuel
system. (See "Bleeding Fuel System" in "SERVICE
AS REQUIRED" in "PERIODIC SERVICE".)
(1) Fuel solenoid pump
PERIODIC SERVICE 127