Fuel Gauge; Coolant Temperature Gauge; Tachometer; Hour / Trip Monitor - Kubota M100GX Operator's Manual

BFuel Gauge
A needle indicates the amount of fuel left regardless of the
key position.
Be careful not to empty the fuel tank. Otherwise air may
enter the fuel system.
Should this happen, the system should be bled (See
"Bleeding Fuel System" in "SERVICE AS REQUIRED" in
"PERIODIC SERVICE" section.)

(1) Fuel gauge

BCoolant Temperature Gauge
To avoid personal injury:
A Do not remove radiator cap until coolant
temperature is well below its boiling point.
Then loosen cap slightly to the stop to relieve
any pressure before removing cap completely.
1. With the key switch at "ON", this gauge indicates the
temperature of the coolant. "C" for "cold" and "H" for
"hot."
2. If the indicator reaches the red zone position, engine
coolant is overheated. Check the tractor by referring to
"TROUBLESHOOTING" section.

(1) Coolant temperature gauge

(A) "FULL"
(B) "EMPTY"
(A) "RED ZONE"
OPERATING THE TRACTOR
BTachometer
The tachometer indicates the engine speed on the dial.
(1) Engine revolution
BHour / Trip Monitor
C Display change
When the RPM dual memory setting is "OFF" and the
Rev-limiter control setting is "
LCD changes "Hour meter mode" and "Trip meter mode"
each time the display switch is pressed. Select the
appropriate display for the work being performed. If the
"RPM dual memory setting" or "Rev-limiter control setting"
is engaged, the set speed takes priority on the display.
(1) LCD monitor
(2) Display switch
C Hour meter mode
The tractor's total operating hours are displayed.
41
", the instrument panel