Replacing Slow-Blow Fuses - Kubota M100GX Operator's Manual

BReplacing Slow-Blow Fuses
The slow-blow fuses are intended to protect the electrical
cabling. If any of them has blown out, be sure to pinpoint
the cause. Never use any substitute, use only a KUBOTA
genuine part.
No. Capacity
1 40A Defogger
2 30A Electrical outlet
3 40A Work light (Rear)
120A [M100GX,
Engine preheat
M110GX]
4
40A [M126GX, Work light (Hood)
M135GX] Head lamp
40A [M100GX, Work light (Hood)
M110GX] Head lamp
5
60A [M126GX,
Engine preheat
M135GX]
6 40A Compressor
7 30A Hazard
8 30A Main key switch
9 140A Alternator
C Replacement procedure
[Non bolt fixed slow-blow fuse:]
1. Disconnect the negative cord of the battery.
2. Pull out the fuse from the fuse box.
3. Replace with a new one of the same capacity.
[Bolt fixed slow-blow fuse:]
Consult your local KUBOTA Dealer for this service.
PERIODIC SERVICE
Protected circuit Type
Non bolt
fixed
Bolt fixed
Non bolt
fixed
Bolt fixed
137