Kubota M100GX Operator's Manual page 70

48 OPERATING THE TRACTOR
Work
Turning
Work
A Keep the hand throttle lever above the minimum
speed. At the minimum speed, a memory setup can
not be performed.
A You can also depress the foot throttle to increase the
engine speed above the set speed.
C Setting the speeds (or changing the speed
settings)
Setting RPM dual memory switch (A)
1. Turn the key switch to
"ON". (The speed setting
can be made both when
the engine is running or
stopped.)
2. Set the hand throttle lever
slightly toward the higher-
speed side.
During work, simply press
the switch to the (A) side
to automatically set an
engine speed of 2000
rpm.
When turning, press the
switch to the (B) side to
lower the speed to 1000
rpm, allowing turning at
low speed.
After turning, press the
switch again to the (A)
side to resume a speed of
2000 rpm.
3. Turn the Rev-limiter
control dial to the "
position.
4. Press the switch (A) side
and then release
switch.
5. Again press and
down the switch (A) side
(2.5 seconds) until the
buzzer sounds,
release the switch.
6. Press the switch to the (A) or (B) side and set the
speed.
Pressing and holding down the switch will cause the
speed to change continuously. Pressing and releasing
the switch changes the speed by 10 rpm each time.
Set the desired engine speed while watching the
speed display.
"
the
hold
then